Abstract

AbstractInformation on water balance components such as evapotranspiration and groundwater recharge are crucial for water management. Due to differences in physical conditions, but also due to limited budgets, there is not one universal best practice, but a wide range of different methods with specific advantages and disadvantages. In this study, we propose an approach to quantify actual evapotranspiration, groundwater recharge and water inflow, i.e. precipitation and irrigation, that considers the specific conditions of irrigated agriculture in warm, arid environments. This approach does not require direct measurements of precipitation or irrigation quantities and is therefore suitable for sites with an uncertain data basis. For this purpose, we combine soil moisture and energy balance monitoring, remote sensing data analysis and numerical modelling using Hydrus. Energy balance data and routine weather data serve to estimate ET0. Surface reflectance data from satellite images (Sentinel‐2) are used to derive leaf area indices, which help to partition ET0 into energy limited evaporation and transpiration. Subsequently, first approximations of water inflow are derived based on observed soil moisture changes. These inflow estimates are used in a series of forward simulations that produce initial estimates of drainage and ETact, which in turn help improve the estimate of water inflow. Finally, the improved inflow estimates are incorporated into the model and then a parameter optimization is performed using the observed soil moisture as the reference figure. Forward simulations with calibrated soil parameters result in final estimates for ETact and groundwater recharge. The presented method is applied to an agricultural test site with a crop rotation of cotton and wheat in Punjab, Pakistan. The final model results, with an RMSE of 2.2% in volumetric water content, suggest a cumulative ETact and groundwater recharge of 769 and 297 mm over a period of 281 days, respectively. The total estimated water inflow accounts for 946 mm, of which 77% originates from irrigation.

Highlights

  • Information on water balance components is essential in hydrological sciences and related disciplines

  • The aim of the present study is to present a method that allows a reliable estimation of the water balance components ETact, groundwater recharge (GWR), and water inflow with moderate measurement efforts

  • Unknown irrigation amounts are estimated based on soil moisture data and an inversion of the soil water balance equation

Read more

Summary

| INTRODUCTION

Information on water balance components is essential in hydrological sciences and related disciplines. The aim of the present study is to present a method that allows a reliable estimation of the water balance components ETact, GWR, and water inflow (precipitation and irrigation) with moderate measurement efforts. This approach is particular suitable for irrigated areas, where irrigation water inflows are insufficiently known and difficult to measure. Unknown irrigation amounts are estimated based on soil moisture data and an inversion of the soil water balance equation This is accompanied by an iterative process in which other required water balance components are estimated stepwise by numerical modelling using Hydrus (Šimunek et al, 2008).

| MATERIALS AND METHODS
| RESULTS AND DISCUSSION
16 August 2018 to 4 May 2019
| CONCLUSION

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.