Estimating the amplitude spectrum area of ventricular fibrillation during cardiopulmonary resuscitation using only ECG waveform

Abstract

BackgroundAmplitude spectrum area (AMSA) calculated from ventricular fibrillation (VF) can be used to monitor the effectiveness of chest compression (CC) and optimize the timing of defibrillation. However, reliable AMSA can only be obtained during CC pause because of artifacts. In this study, we sought to develop a method for estimating AMSA during cardiopulmonary resuscitation (CPR) using only the electrocardiogram (ECG) waveform.MethodsIntervals of 8 seconds ECG and CC-related references, including 4 seconds during CC and an adjacent 4 seconds without CC, were collected before 1,008 defibrillation shocks from 512 out-of-hospital cardiac arrest patients. Signal quality was analyzed based on the irregularity of autocorrelation of VF. If signal quality index (SQI) was high, AMSA would be calculated from the original signal. Otherwise, CC-related artifacts would be constructed and suppressed using the least mean square filter from VF before calculation of AMSA. The algorithm was optimized using 480 training shocks and evaluated using 528 independent testing shocks.ResultsOverall, CC resulted in lower SQI [0.15 (0.04–0.61) with CC vs. 0.75 (0.61–0.83) without CC, P<0.01] and higher AMSA [11.2 (7.7–16.2) with CC vs. 7.2 (4.9–10.6) mVHz without CC, P<0.01] values. The predictive accuracy (49.2% vs. 66.5%, P<0.01) and area under the receiver operating characteristic curve (AUC) (0.647 vs. 0.734, P<0.01) were significantly decreased during CC. Using the proposed method, the estimated AMSA was 7.1 (5.0–15.2) mVHz, the predictive accuracy was 67.0% and the AUC was 0.713, which were all comparable with those calculated without CC.ConclusionsUsing the signal quality-based artifact suppression method, AMSA can be reliably estimated and continuously monitored during CPR.