Estimating Lumbar Spine Least Significant Change for Fewer than Four Vertebrae: The Manitoba BMD Registry

Abstract

Introduction: The International Society of Clinical Densitometry recommends omitting lumbar vertebrae affected by structural artifact from spine BMD measurement. Since reporting fewer than 4 vertebrae reduces spine BMD precision, least significant change (LSC) needs to be adjusted upwards when reporting spine BMD change based on fewer than 4 vertebrae.Methodology: In order to simplify estimating LSC from combinations of vertebrae other than L1-L4 (denoted LSCL1-4 ), we analyzed 879 DXA spine scan-pairs from the Manitoba BMD Program's ongoing precision evaluation. The additional impact on the LSC of performing the second scan on the same day vs different day was also assessed.Results: LSC progressively increased when fewer vertebrae were included, and also increased when the scans were performed on different days. We estimated that the LSCL1-4 should be adjusted upwards by 7 %, 24 % and 65 % to approximate the LSC for 3, 2, or 1 vertebral body, respectively. To additionally capture the greater LSC when the precision study was done on different days, LSCL1-4 derived from a precision study where scans were done on the same day should be adjusted upwards by 39 %, 60 % and 112 % for 3, 2, or 1 vertebral body, respectively.Conclusion: LSCL1-4 derived from a precision study where scans are performed on the same day can be used to estimate LSC for fewer than 4 vertebrae and for scans performed on different days.