Abstract
Estimating the housing vacancy rate (HVR) has always been a hard-to-break point in the study of housing vacancy. This paper used nighttime light and POI (point of interest) data to estimate the HVR in the main urban area of Xi’an city based on extracting built-up areas. The built-up area was extracted using the threshold method, and the spatial resolution of the results was 130 m (same as Luojia-1). Meanwhile, after removing the non-residential areas from the images, the HVRs for the period 2018–2019 from four nighttime light images were calculated, and the HVR of the main urban area of Xi’an city was estimated using the average method and its spatial patterns were analyzed. The results show that: (1) Luojia-1 has great advantages in estimating urban HVRs. The HVRs calculated by Luojia-1 were characterized by a high resolution and a short calculation time. (2) After estimating the results of the four scenes’ remote sensing images, it was found that the results obtained using the average were closest to the actual vacancy situation, and the spatial distribution of the vacancy could be seen using the minimum values. (3) The overall housing occupancy in Xi’an city was good, and the HVRs were low, but the overall vacancy rate for the edge of the built-up area was high. The government should devote more attention to places with high HVRs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.