Abstract

This paper illustrates the possibility of measuring chlorophyll (Chl) content and Chl fluorescence parameters by the solar-induced Chl fluorescence (SIF) method using the Fraunhofer line depth (FLD) principle, and compares the results with the standard measurement methods. A high-spectral resolution HR2000+ and an ordinary USB4000 spectrometer were used to measure leaf reflectance under solar and artificial light, respectively, to estimate Chl fluorescence. Using leaves of Capsicum annuum cv. 'Sven' (paprika), the relationships between the Chl content and the steady-state Chl fluorescence near oxygen absorption bands of O2B (686nm) and O2A (760nm), measured under artificial and solar light at different growing stages of leaves, were evaluated. The Chl fluorescence yields of ΦF 686nm/ΦF 760nm ratios obtained from both methods correlated well with the Chl content (steady-state solar light: R(2) = 0.73; artificial light: R(2) = 0.94). The SIF method was less accurate for Chl content estimation when Chl content was high. The steady-state solar-induced Chl fluorescence yield ratio correlated very well with the artificial-light-induced one (R(2) = 0.84). A new methodology is then presented to estimate photochemical yield of photosystem II (ΦPSII) from the SIF measurements, which was verified against the standard Chl fluorescence measurement method (pulse-amplitude modulated method). The high coefficient of determination (R(2) = 0.74) between the ΦPSII of the two methods shows that photosynthesis process parameters can be successfully estimated using the presented methodology.

Highlights

  • Chlorophyll (Chl) fluorescence has been studied as a useful probe for photosynthesis research

  • To progress our understanding of the potential to detect solar-induced Chl fluorescence (SIF) signals from vegetation reflectance to study photosynthesis, the main objective of this paper is to evaluate the performance of the SIF measurement method throughout the lifespan of leaves with varying Chl content through comparison with the standard Chl measurement method

  • This paper illustrates the possibility of measuring Chl content and Chl fluorescence parameters using SIF measurement (FLD method) and the saturation pulse method via a red laser at different life stages of plant leaves

Read more

Summary

Introduction

Chlorophyll (Chl) fluorescence has been studied as a useful probe for photosynthesis research It has been extensively applied for active phenotyping remote sensing of photosynthetic functioning, and for studying biotic and abiotic stress in plants (Omasa, 1998; Omasa et al, 1987, 2007; Lichtenthaler et al, 1992; Kolber et al, 1998; Kim et al, 2001; Omasa and Takayama, 2003; Schreiber, 2004; Moya et al, 2004; Konishi et al, 2009; Pieruschka et al, 2012; 2014). The technique is capable of measuring Chl fluorescence up to a distance of 50 m but there are still challenges for more longdistance remote sensing (Kolber et al 2005; Pierurschka et al 2012; 2014)

Objectives
Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.