Estimated diameter increase from a 4S to a 6S hamstring graft configuration - A cadaveric study.

Abstract

Graft diameter in anterior cruciate ligament reconstructions has been shown to influence the risk of failure. It is therefore important to be able to adjust the graft configuration to modify the diameter. To measure the impact of a 6-strand (6S) hamstring autograft configuration on graft diameter compared to the standard 4-strand (4S) configuration. Cadaveric study on 33 knees, using the usual hamstring graft harvesting technique. Semitendinosus and gracilis tendons were harvested and their length, width, and diameter were measured in 4S and 6S configurations separately by three evaluators. 6S configuration leads to a median increase of 1.5 (range: 0.0-2.0) mm in diameter compared to 4S (p<0.001). A graft diameter of more than 8mm is attained in less than a third of 4S grafts within this population in comparison to 84% when the 6S configuration is used. The 6S hamstring graft configuration increases the graft diameter by a median of 1.5 millimeters compared to the traditional 4S configuration. It can reliably be used to obtain an 8.5mm graft diameter or more in cases where the semitendinosus measures at least 270.5mm and the 4S configuration has a diameter of 7.5mm or 8mm. This information helps to better delineate the impact of a 6S configuration in a pre-operative or intra-operative setting to optimize the decisional process and surgical flow and to easily adapt the graft diameter. V (cadaveric study).