Establishment of beam qualities for medical applications (mammography and CT) in the gamma and X calibration laboratory of CNESTEN according to EN 61267 standards

Abstract

The present study aimed to validate the different radiodiagnostic beam qualities (RQT, WAH and WAV) by the measurements of the X-ray beams HVL of a HOPEWELL generator, X80-225 kV from a high voltage range of 10 at 200 kV, at CNESTEN Gamma and X Calibration Laboratory. The experiments were carried out using the PTW TN 32005 ionization chamber, established at 100 cm from the center of the X-ray tube and connected to a SUPERMAX electrometer. The HVL values were measured by applying the attenuation law to the flow of Kair air kerma, including their uncertainties. The obtained HVL values were compared with standard values of diagnostic levels. It was observed that the HVL of the present X-ray machine in most qualities are smaller than the standard ones. An approved method (described in the STANDARD EN 61267 and IAEA TECHNICAL REPORTS SERIES n° 457) was applied to determine the amount of additional filtration required to meet the standard values, and by checking their compliance with the maximum absolute deviation. The results indicate the adequacy of the LEGX laboratory for the calibration of the radiation detection instruments used in computed tomography and mammography with an expanded uncertainty in the best measurement capability of ±4 % (k = 2).