Abstract
Two possible sources of error in strain measurement at high frequency were considered. The performance of the strain gauge itself was measured by comparison with a reference transducer. Several installations were shown to he satisfactory at up to 100 Hz hut another showed a progressive attenuation with frequency. Attempts to reproduce the fault with another installation were unsuccessful. The sources of error within the instrumentation were also considered and measurements made on the dynamic performance of several voltmeters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
