Abstract
A novel poly(methyl methacrylate–ethyleneglycol dimethacrylate–acrylic acid) film has been introduced for coating on stir bars to sorptive extraction (SBSE). The effects of different contents of porogen, monomer, cross-linker, modifier and initiator during the solvent or bulk polymerization step on the mechanical property and solvent resistant of prepared sorptive stir bars were investigated. The evaluation of results were caused to obtain the four prepared sorptive stir bars with good mechanical stability and excellent resistance to organic solvents. The extraction efficiency of these prepared sorptive stir bars were investigated by liquid desorption-liquid chromatography-ultraviolet detection (LD-LC-UV) using N-Nitrosodiphenylamine as target analyte. SBSE assays showed the sorptive stir bar that prepared using solution polymerization method had the better recovery for N-Nitrosodiphenylamine in water samples. This sorptive stir bar showed good linearity and acceptable recoveries, as well as advantages such as sensitivity, simplicity, low cost and high feasibility. Based on atomic force microscopy (AFM) results, the average pore size of optimum prepared stir bar using solvent polymerization method was obtained ~9 nm. The thermal gravity (TG) and differential scanning calorimetric (DSC) results showed this polyacrylate film has high thermal stability.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
