Abstract
1) Page 109—After Equation (11) the following should be revised as follows (underlining shows corrected text): ‘‘where sx and sy5compressive stresses in the joint in the xand y-directions (0.95 MPa and 0.28 MPa, respectively), and txy5shear stresses in the joint (2.33 MPa). The principal tensile stress was st51.74 MPa or 0.30 Afc8, and the principal compressive stress was found as sc52.97 MPa or 0.09 fc8...In the present case the curvature ductility exceeds 7.0, so the capacity for principal tension is 0.29 Afc8 (MPa) which was exceeded by a factor of 1.03.’’
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
