Abstract
The present investigation describes the use of biochar derived from an agricultural waste: the maize cob for the biosorption of Cd(II) ion. The biochar was characterized using scanning electron microscopy, surface area analysis, and Fourier transform infra-red spectroscopy. Batch experiments were performed to investigate the effects of parameters such as pH (2.0–8.0), dosage (0.2–1.2 g), contact time (5–300 min), initial metal concentration (10–100 mg L−1), and temperature (20–50 °C). Kinetic data were properly fitted with the pseudo-second-order model, with the qe (cal) value (17.21 mg g−1) closer to the qe (exp) value (18.82 mg g−1). The adsorption data conforms best to the Langmuir isotherm as revealed by the lower non-linear Chi square (χ2) value of 0.15 and a higher correlation value of 0.98 when compared to the Freundlich with a high χ2 value of 2.65 and lower correlation value of 0.96. The maximum adsorption capacity for the biochar was 33.0 mg g−1. The thermodynamic parameters ΔG0, ΔS0 and ΔH0 confirmed that the biosorption was feasible, spontaneous, and endothermic. The results obtained suggest that using a low-cost biochar biosorbent for removing trace metals in contaminated water treatment plants may have great ecological and environmental significance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
