Abstract
A buckled beam with immovable pinned ends is considered. Attached to the beam are either one concentrated mass, two concentrated masses, a spring–mass system (that could model a human, robot, or passive vibration absorber), or a horizontal rigid bar with two vertical end springs (a “bounce–pitch” system that could model an animal or a vehicle). In the theoretical analysis, the beam is modeled as an inextensible elastica. Equilibrium configurations are determined first. Then small free vibrations about equilibrium are examined, and the lowest frequencies and corresponding modes are computed. The effects of various parameters are investigated, such as the ratio of the span to the total arc length of the beam, the locations and weights of the attached masses and systems, and the stiffnesses of the springs. For the case of a single attached mass, experiments are conducted and the results are compared to the theoretical ones.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.