Abstract
Compositional characterization of metal-DLC (metal-containing diamond-like carbon) hard coatings is carried out by (WDS)-EPMA and MCs+-SIMS. EPMA enables accurate (± 5% relative) quantitative analysis including minor concentrations (0.1–10 at%) of N, O and Ar. Under conditions of “near-surface” EPMA (E0 < 10 keV) the influence of surface oxide films on “pure” metal standards may be a limiting factor in respect of accuracy. Depth profiling of sufficiently “thick” layered structures (film thickness ≥ 2 μm) is carried out by EPMA-line scans along mechanically prepared bevels. The depth resolution is about 0.2 μm. SIMS in the MCs+-mode enables high resolution (< 20 nm) depth profiling of metal-DLC layered structures including the determination of H (1–20 at%). MCs+-SIMS, i.e. employing Cs+ primary ions and monitoring MCs+ molecular secondary ions (M is the element of interest) is presented as a promising route towards sufficiently accurate (10–20%) SIMS-quantification. Matrix-independent relative sensitivity factors for MCs+-SIMS are derived from homogeneous coating materials defined by EPMA. EPMA proves to be also useful to detect problems related to SIMS of Ar in metal-DLC materials. The combination EPMA-SIMS is demonstrated as an effective analytical strategy for quality control in industrial production and to support the development of metal DLC layered structures with optimum tribological properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.