Abstract

Enzymatic hydrolysis of native collagen and fibrinogen was carried out under comparable conditions at room temperature. The molecular weight parameters of proteins before and after hydrolysis by thrombin were monitored by gel-penetrating chromatography (GPC). An analysis of the experiment results shows that the molecular weight parameters of the initial fibrinogen (Fn) and cod collagen (CC) are very similar. High molecular CC decays within the first minute, forming two low molecular fractions. The main part (~80%) falls on the fraction with a value of Mw less than 10 kDa. The initial high molecular fraction of Fn with Mw ~320–340 kDa is not completely hydrolyzed even after three days of control. The presence of low molecular fractions with Mw ~17 and Mw ~10 kDa in the solution slightly increases within an hour and noticeably increases for three days. The destruction of macromolecules of high molecular collagen to hydrolysis products appears almost completely within the first minute mainly to the polymer with Mw ~10 kDa, and enzymatic hydrolysis of fibrinogen proceeds slower than that of collagen, but also mainly to the polymer with Mw ~10 kDa. Comparative photos of the surfaces of native collagen, fibrinogen and the scaffold based on them were obtained.

Highlights

  • Scaffold technology is the most dynamically developing direction in tissue engineering.Fibrinogen/fibrin and collagen are among the most popular natural polymers for the formation of hydrogel scaffolds [1,2]

  • The analysis of the molecular weight values shows that the values of the molecular weight range (Mw) fraction, the share of which is the largest in the initial samples of Fn and cod collagen (CC), differ: Fn has a slightly higher value

  • The presence of two low molecular fibrinogen fractions is explained by the partial hydrolysis of the protein

Read more

Summary

Introduction

Scaffold technology is the most dynamically developing direction in tissue engineering.Fibrinogen/fibrin and collagen are among the most popular natural polymers for the formation of hydrogel scaffolds [1,2]. Scaffolds formed on the basis of fibrinogen and collagen can have a high degree of hydration, porosity, and a microfiber structure, which provides an extensive surface area for cells’ attachment and conditions for maintaining their viability, migration, and proliferation [7,8]. The demand for these proteins in tissue engineering is, to a large extent, related to their biological activity.

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call