Abstract
Non-edible bio-oil derived from lignocellulosic biomass could be used as environmentally friendly lubricant-ester base stock for maritime and road-type transportations. However, the use of crude bio-oil with highly oxygenated compounds required further upgrading to yield ester that mimicked the characteristics of Group V base oil (polyolesters). In this study, bio-oil based polyolesters was produced via esterification using green biopolymer alginate acid catalyst (Al-Alg). The bio-oil compounds used were acetic acid (AcA), propionic acid (PrA) and levulinic acid (LA), while polyols such as neopentyl glycol (NPG), trimethylolpropane (TMP) and pentaerythritol (PE) were used. Optimization studies revealed that NPG-PrA ester gave the best ester purity of 100%, with 95% of diester selectivity under optimum conditions of 15 wt% Al-Alg, 8 h, 6:1 PrA:NPG and 140 °C. The produced polyolesters showed potential lube characteristics with viscosity index of 76, kinematic viscosity of 2.3 mm2 s−1 at 40 °C and oxidative induction time of 15 min at 100 °C. Furthermore, a reusability study of the Al-Alg catalyst indicated high NPG-PrA diester selectivity (above 90%) for 8 consecutive cycles. The physico-chemical properties of spent Al-Alg catalyst were also discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.