Abstract
In this paper, environment-friendly electroless metallization of copper (Cu) on acrylonitrile–butadiene–styrene (ABS) parts fabricated through fused deposition modelling route of rapid prototyping process has been proposed. The metallization process eliminates etching as well as the use of high cost palladium (Pd) for activation. For surface preparation, aluminium (Al)-enamel paste has been used. Five different acidic baths are used for electroless Cu deposition. Each bath contains 15 wt% copper sulfate (CuSO4) solution and 5 wt% of any one solution among hydrofluoric acid (HF), sulfuric acid (H2SO4), phosphoric acid (H3PO4), nitric acid (HNO3) and acetic acid (CH3COOH). Metallization of Cu on ABS part has been made at different deposition time (2, 24, 48 and 72 h) in ambient condition. After successful deposition of Cu, the surfaces are characterized by scanning electron microscopy and energy dispersive X-ray spectrometry. Adhesion assessment of samples in different baths has been made. It is observed that all baths are capable of formation of Cu crystals on ABS surface. However, superior deposition on surface in terms of electrical conductivity and uniformity in deposition surface is obtained in HF, H2SO4 and H3PO4 baths.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
