Environmental friendly approach for selective extraction and recovery of molybdenum (Mo) from a sulphate mediated spent Ni–Mo/Al2O3 catalyst baked leach liquor

Abstract

Solvent extraction separation of molybdenum (Mo) from the sulphate mediated leach solution bearing Aluminium (Al) and Nickel (Ni) was carried out using N-Methyl-N, N, N-tri-octyl-ammonium chloride. Extensive investigation for extraction study molybdenum in the function of time, Eq.pH, extractant concentration, diluents, temperature, strip solution concentration and phase ratio(A:O) for both extraction and stripping was examined to attain a suitable condition on its selective and enriched extraction. As per the equilibrium study and increasing trend of Eq. pH (pHe) at the correspondence initial pH, it was apparent about association of 1 mol of H+ ion during extraction which with was further supported on extraction of Mo as HMO4- at the pHe of 3.48. The association of 1 mol of exrractant during the extraction of Mo was also well evident from the slope analysis study. This indicates about anion exchange phenomenon due to Cl− ion of the N-Methyl-N, N, N-tri-octyl-ammonium chloride (extractant) with HMo4− from aqueous phase during complex formation reaction. The FTIR of the organic sample before and after extraction further confirms in support of the complex formation of the molybdenum with the extractant during extraction. The extraction isotherm was constructed at optmum extraction condition: pHe of 3.48 with 0.08M N-Methyl-N, N, N-tri-octyl-ammonium chloride predicts on need of 2-counter current stages for quantitative extraction of Mo at A:O = 3:1. To investigate the regeneration behaviour of adopted extractant along with enriched stripping of molybdenum, ammoniacal reagents were used in stripping study. The stripping of Mo showed promising and efficient using the mixture of the ammoniacal reagents (NH4OH + NH4Cl) over the either of the solo reagents. The stripping Mc-Cabe Thiele diagram was plotted using 2M NH4OH + NH4Cl ensures on quantitative stripping of Mo at SO: SS = 2:1 at 2 no. of stages. Both extraction and stripping isotherm results are validated at predicted isotherm conditions by 6-cycles counter current simulation (CCS) study leading to obtain 6-fold enrichment of Mo in stripped solution phase. The subsequent enriched content of Mo (∼60 g/L) in stripped solution phase was precipitated out followed by calcinations 400 °C to obtain a high pure MoO3. The recovered calcined product as MoO3 resulted through the proposed processing approach was as ascertained from XRD analysis.