Abstract
The polycyclic aromatic hydrocarbon concentration in plastic products is regulated in (European Union) No. 1272/2013. However, this only covers the end products and not intermediate substances. Therefore, a generic method was developed to analyze the polycyclic aromatic hydrocarbons listed by the Environmental Protection Agency and the European Union. This method is based on direct large volume injection from solutions of plastic additives followed by liquid chromatography coupled to fluorescence detection. The additives Irganox 1010, ureido methacrylate, and cetyl methacrylate 1618F were used as examples for method development. Two serially coupled columns allowed the matrix to be removed on the first column and the analytes to be separated on the second column. The columns were connected by an intermediate valve. The valve allowed the matrix to be diverted after the first column and water to be dosed upstream of the second column via an additional pump. This allowed samples in aqueous or organic media to be focused at the column head. An injection volume of 100μl and online aqueous dilution of 1:3 led to a limit of detection below 1ng/ml for 15 polycyclic aromatic hydrocarbons. Moreover, concentrations between 1.6 and 10.3ng/ml were found in the three plastic additives.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
