Enlarging the thermal coagulation volume during thermochemical ablation with alternating acid-base injection by shortening the injection interval: A computational study

Abstract

Background and objectivesThermochemical ablation (TCA) is a cancer treatment that utilises the heat released from the neutralisation of acid and base to raise tissue temperature to levels sufficient to induce thermal coagulation. Computational studies have demonstrated that the coagulation volume produced by sequential injection is smaller than that with simultaneous injection. By injecting the reagents in an ensuing manner, the region of contact between acid and base is limited to a thin contact layer sandwiched between the distribution of acid and base. It is hypothesised that increasing the frequency of acid-base injections into the tissue by shortening the injection interval for each reagent can increase the effective area of contact between acid and base, thereby intensifying neutralisation and the exothermic heat released into the tissue. MethodsTo verify this hypothesis, a computational model was developed to simulate the thermochemical processes involved during TCA with sequential injection. Four major processes that take place during TCA were considered, i.e., the flow of acid and base, their neutralisation, the release of exothermic heat and the formation of thermal damage inside the tissue. Equimolar acid and base at 7.5 M was injected into the tissue intermittently. Six injection intervals, namely 3, 6, 15, 20, 30 and 60 s were investigated. ResultsShortening of the injection interval led to the enlargement of coagulation volume. If one considers only the coagulation volume as the determining factor, then a 15 s injection interval was found to be optimum. Conversely, if one places priority on safety, then a 3 s injection interval would result in the lowest amount of reagent residue inside the tissue after treatment. With a 3 s injection interval, the coagulation volume was found to be larger than that of simultaneous injection with the same treatment parameters. Not only that, the volume also surpassed that of radiofrequency ablation (RFA); a conventional thermal ablation technique commonly used for liver cancer treatment. ConclusionThe numerical results verified the hypothesis that shortening the injection interval will lead to the formation of larger thermal coagulation zone during TCA with sequential injection. More importantly, a 3 s injection interval was found to be optimum for both efficacy (large coagulation volume) and safety (least amount of reagent residue).