Enhancing the physico-mechanical properties of ethylene propylene diene monomer rubber via ץ-radiation in the presence of bi-functional and tri-functional monomers

Abstract

Abstract This study, uses two polyfunctional monomers (PFMs) namely ethylene glycol dimethacrylate (EGDMA) as a bifunctional monomer and trimethylolpropane triacrylate (TMPTA) as a trifunctional monomer were used as co-agents in irradiation crosslinking of Ethylene Propylene Diene Monomer Rubber (EPDM). The effect of concentration of each PFM and irradiation dose on the crosslinking density, gel content, swelling behavior in motor and brake oils, in addition to the mechanical and thermal stability properties of EPDM was investigated in detailed. The results showed a remarkable increase in the gel content, crosslinking density and mechanical properties as the concentration of PFMs increased from 1 to 5 phr (parts per hundred parts of rubber). The various blends of EPDM with the trifunctional monomer express the highest gel content and crosslinking density than those with the bifunctional monomer. The addition of 5 phr of TMPTA to EPDM causes a dramatic improvement in tensile strength (TS) of the prepared blend reached to 188% compared to neat EPDM at 50 kGy. At the same time, the maximum TS of the blend containing 5 phr of EGDMA achieved only 41% compared to neat EPDM at an irradiation dose of 100 kGy. The swelling of irradiated samples in brake oil revealed a stronger oil resistance than motor oil. For all irradiated samples, the oil uptake decreased with the irradiation dose up to 100 kGy. The EPDM samples containing 5 phr of TMPTA recorded the highest oil resistance at 100 kGy. The results also showed that the addition of PFMs and irradiation treatment of the various prepared blends improved the thermal stability of EPDM. Finally, neat EPDM and the blends containing 1 and 3 phr of EGDMA can be used as radiation dosimeters in the very high dose range (50–200 kGy).