Enhancing the corrosion resistance of high Mo S31254 super austenitic stainless steel using grain boundary engineering

Abstract

Super austenitic stainless steel (SASSs) with a high Mo content exhibit excellent resistance to intergranular corrosion (IGC), Its mechanical properties mainly depend on solid solution strengthening. Meanwhile, grain boundary engineering (GBE) can simultaneously improve the corrosion resistance and mechanical properties of Mo-rich austenitic stainless steel using the resistance to IGC of Mo. However, recrystallization annealing is extremely difficult due to the sensitive precipitation of Cr-rich and Mo-rich precipitations in SASSs. Therefore, this study explores the effect of large deformation, high temperature, and short-time annealing on the corrosion resistance of SASSs. The results show that a recrystallized organization with an average grain size of 13.3 μm was prepared by 50% cold rolling deformation and 2min high-temperature short-time annealing at 1150 °C. The highest percentage of Σ3 GBs is about 34%, the percentage of other low-energy GBs is relatively low (only about 6%), and the rest are random high-angle grain boundaries (RHAGBs), which account for about 60%. It can be seen the corrosion resistance of random GBs after GBE treatment is superior to that of solution treatment. Meanwhile, medium-temperature aging improved the resistance to IGC of SASSs, especially after aging at 450 ℃, a small amount of Mo is enriched along the GBs, which promotes the formation of Cr2O3 and Mo-rich oxides in the passivation film and improves the corrosion resistance. The above results provide guidance for improving the corrosion resistance of Mo-rich austenitic stainless steels.