Enhancing dry sliding wear resistance of high-Mn austenitic steel by adding N

Abstract

In this study, the wear resistance of two high-Mn austenitic steels, i.e., Fe−18.5Mn−7Cr−0.6C and Fe−18.5Mn−7Cr−0.6C−0.21N was tested in dry sliding friction on a disc friction and wear testing machine (MMU-5G). The wear behavior and microstructure evolution of the two tested steels were investigated. The results revealed that adding N enhanced the wear resistance of high-Mn austenitic steel due to the synergistic effects of hardness, wear hardening, and oxide layer. Interstitial N atoms increased the matrix hardness and decreased the stacking fault energy (SFE). The lower SFE facilitated wear hardening, and the active mechanical twins along with the higher dislocation density induced the formation of a thicker nanocrystalline layer with finer grains. The nanocrystalline layer with higher surface activity promoted the adsorption of a protective oxide layer. These factors decreased the surface roughness, coefficient of friction (COF), and wear rate of N-alloyed high-Mn austenitic steel. This study provided valuable insights into the application of N-alloyed high-Mn austenitic steels under dry sliding friction conditions.