Enhancement of wettability in low density polyethylene films using low pressure glow discharge N2 plasma

Abstract

AbstractLow pressure glow discharge nitrogen plasma has been used to improve wettability in a low density polyethylene (LDPE) film for technical applications. The plasma treatment was carried out at a power of 300 W for different exposure times in the 1–20 min range. Wettability changes were analyzed using contact angle measurements. In addition to this, plasma‐treated samples were subjected to an aging process to determine the durability of the plasma treatment. X‐ray photoelectron spectroscopy, atomic force microscopy, and scanning electron microscopy were used for surface characterization. The nitrogen plasma treatment considerably reduced contact angle values thus indicating an increase in surface wettability. The spectroscopic study showed presence of oxygen‐based species on the plasma‐treated samples, which are mainly generated after the plasma treatment as a consequence of air exposure. These polar species contribute to improve surface functionalization, but this is almost lost during aging due to the hydrophobic recovery process. Microscopic studies revealed that also small changes in surface roughness occurred during the plasma treatment but these are very low compared to surface activation. The results confirmed that low pressure nitrogen can be considered as an environmentally efficient process to improve wettability in low density polyethylene films. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2390–2399, 2007