Enhancement of the part-load thermal charging performance of a latent heat thermal energy storage unit with variable length fins at effective locations

Abstract

Rapid thermal charging of the latent heat thermal energy storage unit (LHTESU) based on phase change material (PCM) is restricted by the material's low thermal conductivity. The numerical investigation for the thermal charging process of LHTESU considering a rectangular enclosure under the high-temperature gradient is presented. Constant and variable length fins with different locations are considered inside the enclosure with one vertical sidewall at a constant temperature. For various part-load thermal charging operations, a two-dimensional transient model with enthalpy-porosity technique is employed with natural convection current to evaluate the thermal charging rate and melting characteristics. The simulation outcomes manifest that convective heat transfer significantly impacts PCM melting in the case of variable length fins. Uniform distribution of Variable length fins with the most extended fin near the base of the container has 20% superior thermal charging performance than of constant length in full load thermal charging operations. However, in half-load thermal charging operations, constant-length fins with uniform distribution in the enclosure reduce the maximum thermal charging time and the average temperature of the PCM domain. Further, the result indicates that Cases VF-2 (most extended fins placed significantly close to the bottom and remaining fins inserted with equal gap) and VF-3 (fins insertion only in the lower half of the container) minimized the sensible heating of liquid PCM by directing the heat towards solid PCM. Case VF-3 demonstrated the most robust thermal charging performance by taking the least melting time in all cases for a 90% thermal charging of the system.