Enhancement of Rheological Properties of Nano-Fe2O3-Modified Drilling Fluids

Abstract

Summary In this study, we explore the potential of using nanoparticles (NPs) to enhance the properties of water-based drilling fluids (WBDFs). Specifically, we investigate the effects of nano-Fe2O3 on the rheological behavior of drilling fluid muds under high-temperature and high-pressure (HTHP) conditions to determine the optimal concentration of Fe2O3 NPs to maintain consistent rheology and improve drilling fluid systems. Results show that as temperature increases, the rheological properties of water-based muds (WBMs) decrease, leading to compromised structural integrity. To address this issue, nano-Fe2O3 is introduced into the system. We prepared and evaluated six WBM formulations with varying weight percentages of Fe2O3 NPs, and found that an optimal NP concentration of 2.5 g wt% resulted in a 13.8% reduction in American Petroleum Institute (API) filtrate volume and a 40% reduction in filter-cake thickness. Under conditions of 300°F temperature and 10,000 psi pressure, consistent reductions were observed in the rheological properties of plastic viscosity (PV), yield point (YP), and gel strength with the addition of Fe2O3 NPs. The YP-PV span was measured at 2.7, and the yield strength was determined to be 11 lb/100 ft2. Regarding fluid loss, Drilling Mudcake A containing 0.5 wt% NPs experienced a loss of 6 mL of fluid after 30 minutes, whereas Mudcake E containing 3 wt% NPs exhibited a fluid loss of 5.1 mL in the API filter press test. According to the Bingham plastic model, Muds E and F, containing 2.5 wt% and 3 wt% NPs, respectively, displayed the maximum shear stress vs. shear rate. This highlights the efficacy of nano-Fe2O3 in adjusting the properties of drilling fluids, presenting opportunities for enhanced performance and efficiency in drilling operations.