Enhancement of nitrogen removal and energy recovery from low C/N ratio sewage by multi-electrode electrochemical technology and tidal flow via siphon aeration

Abstract

In view of the difficulty in denitrification of low C/N ratio wastewater, electrochemical technology with multiple electrodes and tidal flow method via siphon aeration were used to enhance the denitrification process. At the same time, because of the low phosphorus removal efficiency in traditional activated sludge process, the constructed wetland and microbial fuel cell (CW-MFC) reactor with dewatered alum sludge (DAS) as substrate were constructed. In addition, the REDOX conditions of the reactor were changed by siphon, which significantly improved the removal efficiency of N and P and the energy recovery capacity of the reactor. In the 172 d, the Tidal Flow Constructed Wetland-Microbial Fuel Cell (TF CW-MFC) had the highest removal efficiency of COD and total nitrogen (TN), which were 97.4% and 83.4%, respectively. Although the removal rate of total phosphorus (TP) by TF CW-MFC was lower than artificial aeration, it can still reached 89.0%. The removal effect of aromatic protein substances in water was also significant. The amount of electrons generated by the artificial aeration anode and the amount of oxygen generated by the cathode were not enough to match. The voltage of TF CW-MFC was significantly higher than artificial aeration, around 350 mV, and the maximum power density was 98.16 mW m−3. In addition, MFC had an inhibitory effect on CW methane emissions. The analysis of the microbial community structure showed that most of the dominant bacteria of TF CW-MFC belonged to the Proteobacteria, Actinobacteria and Chloroflexi. These results showed that the TF CW-MFC technology as a zero-energy oxygen supply mode had high efficiency in the treatment of low C/N ratio wastewater and also had the environmental effect of reducing methane emissions. This study suggests that this green wastewater treatment technology has potential application value.