Abstract

The dye wastewater produced in the printing and dyeing industry causes serious harm to the natural environment. TiO2 usually shows photocatalytic degradation of dye under the irradiation ultravilet light rather than visible light. In this work, a large number of oxygen vacancies and Ti3+ defects were generated on the surface of the TiO2 nanoparticles via Ar plasma. Compared with pristine TiO2 nanoparticles, the as-obtained Ar plasma-treated TiO2 (Ar-TiO2) nanoparticles make the energy band gap reduce from 3.21 eV to 3.17 eV and exhibit enhanced photocatalytic degradation of organic dyes. The Ar-TiO2 obtained exhibited excellent degradation properties of methyl orange (MO); the degradation rate under sunlight irradiation was 99.6% in 30 min, and the photocatalytic performance was about twice that of the original TiO2 nanoparticles (49%). The degradation rate under visible light (λ > 400 nm) irradiation was 89% in 150 min, and the photocatalytic performance of the Ar-TiO2 was approaching ~4 times higher than that of the original TiO2 nanoparticles (23%). Ar-TiO2 also showed good degradation performance in degrading rhodamine B (Rho B) and methylene blue (MB). We believe that this plasma strategy provides a new method for improving the photocatalytic activity of other metal oxides.

Highlights

  • Printing and dyeing wastewater has caused serious pollution to the environment [1,2], and it is necessary to seek an effective treatment of printing and dyeing wastewater [3]

  • The XRD pattern of the modified TiO2 has a higher strength than the original TiO2, which indicated that the Ar plasma caused an improvement in the crystallinity of the modified TiO2

  • Low temperature dielectric barrier discharge (DBD) plasma was successfully employed to treat the surface of TiO2 nanoparticles in Ar atmosphere

Read more

Summary

Introduction

Printing and dyeing wastewater has caused serious pollution to the environment [1,2], and it is necessary to seek an effective treatment of printing and dyeing wastewater [3]. Low temperature plasma can cause defects and oxygen vacancies on the catalyst surface to improve the catalytic efficiency [42,43,44]. Nanowires and nanoparticles of TiO2 treated under a hot hydrogen atmosphere have better photocatalytic degradation of dye properties because of the presence of oxygen vacancies and Ti3+ forming an intermediate layer [45,46]. The application of oxygen and nitrogen plasma reduced the TiO2 powder and produced an intermediate state, resulting in an increase in its optical activity in the visible region [47]. The results showed that the plasma-etched TiO2 nanoparticles had more oxygen vacancies and Ti3+ defects than of the original TiO2, and have excellent photocatalytic degradation properties under sunlight. We believe that DBD plasma provides a new strategy for etching the surface of catalysts

Sample Preparation
Catalyst Characterization
Photocatalytic Activity Measurements
Apparent Quantum Efficiency Measurement
Physicochemical Properties of Catalysts
Photocatalytic Performance
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call