Abstract
Efficient and space-saving technologies for on-site treatment of stormwater runoff are required to control water pollution in the urban surface. The intermittent nature of stormwater runoff and extremely limited land available greatly hindered the application of current wastewater treatment technologies, and thus synchronous removal of multiple contaminants (especially for nutrient) efficiently was failed by current processes. In this study, a new compact CFFA treatment system, consisting of coagulation, flocculation, filtration and ammonium ion exchange units, was constructed for on-site treatment of stormwater runoff based on batch test optimization and pilot-scale test verification. The coagulation process effectively aggregated particles and precipitated phosphorus by dosing Al2(SO4)3, while flocculation using anionic polyacrylamide further enlarged particle size for efficient micromesh filtration. The dynamic micromesh filtration obtained turbidity and phosphorus removal efficiencies comparable to 30 min gravity settling with greatly smaller footprint. Ion exchange by zeolite showed higher exchange capacity owing to lower initial ammonium nitrogen concentration in the stormwater runoff. The pilot-scale experiments with treatment capacity of 1 L/s showed that the CFFA treatment system achieved synchronous removal of particles (97.2%), nitrogen (79.7%), phosphorus (95.0%) and organic matters (83.3%) efficiently within short hydraulic retention time of 0.35 h, yielding effluent with chemical oxygen demand, suspended solids, total phosphorus and total nitrogen of 38.7, 7.80, 0.22 and 2.80 mg/L, respectively. The CFFA treatment system had the highest pollutant removal loads compared to reported runoff treatment processes in literatures, and was well suited to on-site treatment of stormwater runoff with high space utilization efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have