Abstract
An enhanced equivalent circuit approach for the magnetic/electric interaction of single split-ring resonators (SRRs) with printed lines is presented in this paper. A very simple and efficient lumped-element network is proposed to model the behavior of metamaterial-based printed lines over a wide frequency band. The same circuit topology can be used for the single- and two-mirrored SRRs loaded microstrip line. The corresponding circuit parameters are obtained from the multiconductor transmission line theory as well as from closed-form expressions that make use of just the resonance frequency and minimum of the reflection coefficient (which should be previously extracted from experiments or full-wave simulations). The comparison of our equivalent circuit results with measurements and full-wave simulations has shown a very good agreement in a considerably wider frequency band than other previously proposed simple equivalent circuits.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Microwave Theory and Techniques
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
