Abstract
The material commonly used in low-pressure high-rating super critical/ultra super critical steam turbines as well as guide and moving blades of high speed aero compressors is Ti6Al4V alloy. These blades are severely affected owing to erosion which leads to drop in efficiency and increase in maintenance cost. This article deals with SHS 7170 coating on Ti6Al4V alloy using twin wire arc spraying (TWAS), enhancing its bonding by providing a thin bond coat and then treating with high-power diode laser (HPDL). Significant improvement in erosion resistance of this multilayer coating has been achieved because of the formation of fine-grained micro structure due to rapid heating and cooling rates associated with the laser surface treatment. After laser surface treatment, the fracture toughness of this multilayer has improved manifold. The water droplet and particulate erosion test results along with the damage mechanism are reported and discussed in this article.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
