Enhanced Electron Transfer Efficiency of Fructose Dehydrogenase onto Roll-to-Roll Thermal Stamped Laser-Patterned Reduced Graphene Oxide Films.

Abstract

Herein, a strategy to stamp laser-produced reduced graphene oxide (rGO) onto flexible polymers using only office-grade tools, namely, roll-to-roll thermal stamping, is proposed, proving for the first time its effectiveness for direct bioelectrocatalysis. This straightforward, scalable, and low-cost approach allows us to overcome the limits of the integration of laser-induced rGO-films in bioanalytical devices. Laser-produced rGO has been thermally stamped (TS) onto different polymeric substrates (PET, PVC, and EVA) using a simple roll-laminator; the obtained TS-rGO films have been compared with the native rGO (untransferred) via morphochemical and electrochemical characterization. Particularly, the direct electron transfer (DET) reaction between fructose dehydrogenase (FDH) and TS-rGO transducers has been investigated, with respect to the influence of the amount of enzyme on the catalytic process. Remarkable differences have been observed among TS-rGO transducers; PET proved to be the elective substrate to support the transfer of the laser-induced rGO, allowing the preservation of the morphochemical features of the native material and returning a reduced capacitive current. Noteworthily, TS-rGOs ensure superior electrocatalysis using a very low amount of FDH units (15 mU). Eventually, TS-rGO-based third-generation complete enzymatic biosensors were fabricated via low-cost benchtop technologies. TS-rGOPET exhibited bioanalytical performances superior to the native rGO, allowing a sensitive (0.0289 μA cm-2 μM-1) and reproducible (RSD = 3%, n = 3) d-fructose determination at the nanomolar level (LOD = 0.2 μM). TS-rGO exploitability as a point-of-need device was proved via the monitoring of d-fructose during banana (Musa acuminata) postharvest ripening, returning accurate (recoveries 110-90%; relative error -13/+1%) and reproducible (RSD ≤ 7%; n = 3) data.