Abstract
Abstract To investigate the effect of surface fluorination on dispersion stability and powder fluidity of rutile TiO2 particles, they were fluorinated using F2 gas under various conditions. Reaction temperature, fluorine pressure and reaction time were set at 25∼200 ℃, 1∼50 kPa, and 1h, respectively. Even at 200℃ of fluorination temperature, the crystal structure did not change in XRD results. Some fluorenes were found on the surface of TiO2 particles in XPS results, and their contents increased with increasing the F2 pressure. From a result of sedimentation test with water, the dispersion stability of TiO2 particles was improved using the surface fluorination. The average size and zeta potentials of fluorinated TiO2 particles were almost 2 times smaller and 2 times larger, respectively, than those (1x103 mm and -20 mV) of untreated TiO2 particles. And in the results of FT4 powder rheometer and repose angle, the powder fluidity of rutile TiO2 particles was improved using surface fluorination. Consequently, the fluorine existed on the surface of TiO2 particles made to improve a dispersion stability and fluidity of TiO2 particles
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
