Year-end Sale % OFF 
Abstract
To improve dielectric properties of SrTiO3-based materials and meet their development requirements in various scientific and technology fields, Mg-doped SrTiO3 nanowire films (with 0, 0.5, 1, 1.5 and 2mol% Mg) were fabricated by liquid phase deposition (LPD) process. The results showed that structural and dielectric properties of the prepared samples can be effectively affected by Mg doping. Thus, the SrTiO3 nanowire film doped with 1.5mol% Mg has high dielectric constant of 594.2, a low dielectric loss of 0.0167 and the highest breakdown strength of 463.1 kV/cm at 1 kHz, therefore resulting in a high energy density of 5.64 J/cm3, which is about 3.9 times higher than that of the pure SrTiO3 nanowire films (1.44 J/cm3). Based on findings in this research, it was shown that improvement of dielectric properties of SrTiO3 ceramic systems can be obtained with formation of one-dimensional structures and selecting reasonable Mg content for doping.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
