Abstract

There are concerns that microplastics act as a vector of pharmaceuticals in the aquatic environment. Most studies have focussed on pharmaceutical adsorption and have not investigated desorption in the various matrices that microplastics enter. Therefore we studied the desorption of the antidepressant drug fluoxetine from polyethylene terephthalate (PET) microplastics in river water, sea water, and simulated gastric and intestinal fluids. We found that most desorption occurred rapidly, within a few hours of exposure. Fluoxetine desorption fitted well to the Freundlich isotherm with r2 values ranging from 0.97 to 0.99. Desorption decreased in the following order: gastric fluid at 20 °C and 37 °C; sea water at 20 °C; intestinal fluid at 20 °C and 37 °C; then river water at 20 °C. The little difference in desorption in gastrointestinal fluids at 20 °C and 37 °C suggests a similar exposure risk to cold- and warm-blooded organisms following PET microplastic ingestion. Total desorption following sequential incubation 2 h in gastric fluid then 4 h in intestinal fluid to mimic gastrointestinal digestion was 37% at 20 °C and 41% at 37 °C. Interestingly, higher desorption of 18–23% occurred in sea water compared to river water, of 4–11%. Under a worst-case scenario, more than 44 mg kg−1 body weight d−1 or more than 52 mg kg−1 body weight d−1 of PET microplastics from river water or sea water, respectively, need to be consumed to exceed the mammalian acceptable daily intake for fluoxetine. Further studies are needed on microplastic ingestion and the bioavailability of adsorbed pharmaceuticals to a range of exposed aquatic organisms.

Highlights

  • Microplastics are plastic pieces smaller than 5 mm in all dimensions (Schmid et al 2021; Dhaka et al 2022)

  • All subsequent samples used to establish adsorption isotherms as well as those microplastics utilised in desorption studies were collected after 24 h mixing to ensure equilibrium conditions were established

  • Fluoxetine is present as the cationic species in the wastewater and electrostatic interactions with the negatively charged microplastic surface as well as hydrophobic interactions are considered important for adsorption (Wagstaff et al 2021)

Read more

Summary

Introduction

Microplastics are plastic pieces smaller than 5 mm in all dimensions (Schmid et al 2021; Dhaka et al 2022). They pose a largely unknown risk to human and environmental health. Common microplastic polymer types found in wastewater include polyamide, polyethylene, and polyethylene terephthalate (PET) (Sun et al 2019). In wastewater, these microplastics are present with a diverse range of pharmaceuticals that can adsorb to their surface (McDougall et al 2021). Pharmaceuticals, School of Pharmacy and Life Sciences, Robert Gordon University, Aberdeen AB10 7GJ, UK by their very nature, can induce effects to exposed organisms once in the environment (Wang et al 2021)

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call