Abstract
Dc power supplies are extensively used inside most of electrical and electronic appliances such as in computers, televisions, audio sets and others.And the electrical energy available in the utility grid is not suitable for direct use .So in particular, applications requiring DC source must involve an interface device between the AC power line and the load requiring the DC voltage. Conventional AC/DC conversion involves diode rectifiers with large capacitor to reduce DC voltage ripple. The filter capacitor reduces the ripple present in the output voltage but draws non sinusoidal line current which reduces the power factor. So power factor correction (PFC) techniques are gaining increasing attention. The most popular topology for active PFC is boost converter as it draws continuous input current. This input current can be manipulated by average current mode control technique. But there are ripple in the input current due to inductor of boost converter which can be minimized by using two phase interleaved boost converter. So here average current mode controlled interleaved boost converter in continuous conduction mode using PI controller, is represented which provides high power factor and low THD
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
