Abstract
This paper investigates the energy efficiency of a pneumatic power transmission which serves as power take-off for a small-scale, low cost, portable wave energy converter. The wave energy converter was implemented and tested as a prototype in the Eastern Mediterranean. The power transmission uses a standard cylinder as a pump with check valves for flow rectification. Air is stored in an accumulator and discharged through a vane motor coupled to a brushed DC generator which is connected to an electrical load. Numerical models are given for each component of the system which allow to calculate the component and system losses for a range of operating conditions.Experimental results are presented from laboratory tests with the power take-off system. Measurements are conducted at steady state, transient, as well as simulated wave conditions using a hydraulic wave simulator. The measurements validate the predicted losses of the numerical models. The losses in each part of the power transmission are graphically illustrated with a Sankey diagram. We conclude that even though the overall efficiency is low, the setup serves well as a low cost instructional tool to teach principles of wave energy harvesting and to demonstrate typical challenges faced in the design of wave energy converters and pneumatic power transmission.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
