Energy Efficiency of Corona Discharge Reactor Driven by Inductive Energy Storage System Pulsed Power Generator

Abstract

Characteristics of a pulse corona reactor driven by an inductive energy storage (IES) pulsed power generator are described in this paper with focusing on the influence of streamer-to-glow transition on NO removal efficiency. A pulsed high voltage with a short rise time of under 30 ns is employed to generate streamer discharges homogeneously in whole the discharge region. Fast recovery diodes are used as semiconductor opening switch (SOS) to shorten the rise time. The various resistors are employed as dummy load to clarify a suitable circuit parameter such as the capacitance of a primary energy storage capacitor and/or the inductance of a secondary energy storage inductor. The energy transfer efficiency of the pulsed power generator has a maximum value of 50% at 714 Omega dummy load resistance. A co-axial cylinder type discharge chamber was used as the corona discharge plasma reactor driven by the IES pulsed power generator. The pulsed power generator supplies 30 kV pulse with 300 pps repetition rate. The co-axial cylinder plasma reactor consists of 1 mm diameter tungsten wire and 19 mm i.d. copper tube with 30 cm length. NO removal from the simulated diesel engine exhaust gas (N <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> :O <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> =9:1, Initial NO concentration=200 ppm) increased with input energy into the reactor. The energy efficiency for NO removal was obtained to be 25 g/kWh at 30 % removal in gas flow rate of 2 L/min. However, the energy efficiency decreased to 5 g/kWh with increasing capacitance of the primary capacitor from several hundreds pF to several nF. This decrease was caused by a streamer-to-glow transition. The efficiency was affected by oxygen concentration in the gas mixture.