Abstract

To improve the ejector refrigeration cycle performance, this paper presents a theoretical thermodynamic analysis of a novel two-stage ejector refrigeration cycle (TSERC) with a gas-liquid separator using R134a/R32 and R600a/R290 as refrigerant. By separating the relatively low-boiling-point and high-boiling-point refrigerants, the cycle compression ratio decreases, the cycle performance increases, and the energy utilization efficiency can be improved. Energy and exergy analysis were conducted for the traditional single-stage ejector refrigeration cycle (SSERC) and TSERC. The effect of the mixture mass fraction on cycle performance under a fixed external heat source operating condition was studied, and the cycle performance comparisons between TSERC and SSERC at different evaporation temperature, condensation temperature and generation temperature were conducted. Results show that for TSERC, the maximum COP values 0.126 and 0.11, the maximum exergy efficiency 4.51 % and 4 % are obtained as the low-boiling-point mass fraction equals 0.6 and 0.4 respectively for R134a/R32 and R600a/R290. It is found that exergy destruction mainly occurs in the low-pressure sub-cycle of TSERC, the top three largest exergy destruction components are ejector 1, condenser 1 and generator 1, while the smallest exergy destruction occurs in pump 2. In addition, cycle performance comparison between SSERC and TSERC shows that the maximum COP improvement increased by 41.6 % and 89.6 % for 134a/R32 and R600a/R290 for TSERC, while the maximum entrainment ratio improvement increased by 32.4 % and 87.6 %. Moreover, it is concluded that the cycle performance improvement of TSERC is more significant at lower evaporation temperature, higher condensation temperature, and lower generation temperature compared to SSERC.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.