Abstract
Heller main cooling tower as air-cooled heat exchanger is used in the combined cycle power plants (CCPP) to reduce the temperature of condenser. In extreme summer heat, the efficiency of the cooling tower is reduced and it lessens performance of Steam Turbine Generation (STG) unit of Combined Cycle Power Plant (CCPP). Thus, the auxiliary cooling system (ACS) is equipped with compression refrigerating system (CRS). This auxiliary system is linked with the Heller main cooling tower and improves the performance of power plant. In other words, this auxiliary system increases the generated power of STG unit of CCPP by decreasing the temperature of returning water from cooling tower Therefore, in the first step, the mentioned auxiliary cooling system (ACS) as a heat exchanger and compression refrigerating system (CRS) have been designed via ASPEN HTFS and EES code respectively. In order to validate their results, these two systems have been built and theirs experimentally obtained data have been compared with ASPEN and EES results. There are good agreements between results. After that, exergic and exergo-economic analysis of designed systems have been carried out. Finally, the compression refrigerating system (CRS) has been optimized via Genetic Algorithm (GA). Increasing in exergy efficiency (ε) from 14.23% up to 36.12% and decreasing the total cost rate (ĊSystem) from 378.2 ($/h) to 308.2 ($/h) are as results of multi-objective optimization.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
