Endwall heat transfer and film cooling measurements in a turbine cascade with injection upstream of leading edge

Abstract

AbstractDetailed heat transfer measurements were conducted on the endwall surface of a large‐scale low‐speed turbine cascade with single and double row injection on the endwall upstream of leading edge. Local film cooling effectiveness and the heat transfer coefficient with coolant injection were determined at blowing ratios 1.0, 2.0, and 3.0. In conjunction with the previously measured flow field data, the behaviors of endwall film cooling and heat transfer were studied. The results show that endwall film cooling is influenced to a great extent by the secondary flow and the coverage of coolant on the endwall is mainly determined by the blowing ratio. An uncovered triangle‐shaped area with low effectiveness close to pressure side could be observed at a low blowing ratio injection. The averaged effectiveness increases significantly when injecting at medium and high blowing ratios, and uniform coverage of coolant on the endwall could be achieved. The averaged effectiveness could be doubled in the case of double row injection. It was also observed that coolant injection made the overall averaged heat transfer coefficient increase remarkably with blowing ratio. It was proven that film cooling could reduce endwall heat flux markedly. The results illustrate the need to take such facts into account in the design process as the three‐dimensional flow patterns in the vicinity of the endwall, the interactions between the secondary flow and coolant, and the augmentation of heat transfer rate in the case of endwall injection. © 2004 Wiley Periodicals, Inc. Heat Trans Asian Res, 33(3): 141–152, 2004; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/htj.20007