Abstract
There are accidents through the low reliability of protective systems of overhead cranes in the end of crane runway. The construction of the dead stop for increasing of the protective systems reliability and ensuring of the safety operation of overhead cranes was suggested. The end stop consists of the fixed frame, curvilinear stop, dismountable side plates, rod with rack bar, that coupled with wheel gear and goes through the frame coupled with compression spring, pegged to the back wall of the curvilinear stop. Suggested construction of dead stop must increase a reliability of protective systems of overhead cranes in the end of crane runway. Operation of this device allows reliably and safely to stop hoist cranes during the accidents.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.