Abstract
This paper presents a new control method to enable large-scale solar photovoltaic (PV) plants to damp electromechanical oscillations. The proposed step-down modulation (SDM) control method is based on active power modulation, and it does not require curtailment as in other approaches. After an oscillation event is detected, the PV panel voltage is controlled to transiently deviate the power from its maximum power point (MPP), this power margin is used to modulate active power until the oscillation event is mitigated. Then, the SDM control restores the PV power to its MPP, and it is reset to operate for the next event. The control design, panel voltage strategy, and implementation is tested in a two-area system. A comparison of the SDM control with a curtailment-based PV damping control is also presented, using a test case of the 179-bus WECC system with six large-scale PV plants, showing the improved damping capability of the proposed method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.