Abstract

We assess if variations in the in situ cosmogenic 26Al/10Be production ratio expected from nuclear physics are consistent with empirical data, knowledge critical for two-isotope studies. We do this using 313 samples from glacially transported boulders or scoured bedrock with presumed simple exposure histories in the Informal Cosmogenic-nuclide Exposure-age Database (ICE-D) from latitudes between 53°S to 70°N and altitudes up to 5000 m above sea level. Although there were small systematic differences in Al/Be ratios measured in different laboratories, these were not significant and are in part explained by differences in elevation distribution of samples analyzed by each laboratory. We observe a negative correlation between the 26Al/10Be production ratio and elevation (p = 0.0005), consistent with predictions based on the measured energy dependence of nuclear reaction cross-sections and the spatial variability in cosmic-ray energy spectra. We detect an increase in the production ratio with increasing latitude, but this correlation is significant only in a single variate model, and we attribute at least some of the correlation to sample elevation bias because lower latitude samples are typically from higher elevations (and vice versa). Using 6.75 as the 26Al/10Be production ratio globally will bias two-isotope results at higher elevations and perhaps higher latitudes. Data reported here support using production rate scaling that incorporates such ratio changes, such as the LSDn scheme, to minimize such biases.

Highlights

  • Paired-nuclide, in situ cosmogenic nuclide analyses are valuable tools for investigating complex landscape histories, including burial after and/or during exposure

  • A surface production ratio that changes with latitude and/or elevation would mean that many of the studies using this dual-nuclide methodology contain systematic biases in their results because the assumed surface production ratio may differ from the actual ratio at the sampling site

  • We focus on the production of in situ cosmogenic 26Al and 10Be in quartz. 26Al and 10Be are produced primarily through spallation reactions in quartz (>95% at sea level and high latitude) with minor production from muon interactions [1,11,12]

Read more

Summary

Introduction

Paired-nuclide, in situ cosmogenic nuclide analyses are valuable tools for investigating complex landscape histories, including burial after and/or during exposure. Physics-based nuclide production models suggest that the 26Al/10Be surface production ratio should decrease with elevation and increase with latitude [19,20]; most analyses of 26Al/10Be data assume a globally constant surface production ratio. A surface production ratio that changes with latitude and/or elevation would mean that many of the studies using this dual-nuclide methodology contain systematic biases in their results because the assumed surface production ratio may differ from the actual ratio at the sampling site. We apply deductive statistical analyses to this compilation to determine if 26Al/10Be ratio variations with altitude, latitude, and sample processing laboratory are present at a statistically significant level This analysis allows us to test whether there are detectable production ratio variations, necessitating application of physics-based nuclide production models in dual-nuclide studies, or if the nominal ratio of 6.75 is suitable at all latitudes and elevations

In Situ Cosmogenic 26Al and 10Be
Data Sources and Sample Selection
Statistical Analyses
Regression Statistics
Discussion
Findings
Implications
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call