Abstract
In a previous paper a new referenceless measurement set-up based on a reference antenna was used for characterizing the radiation of antennas in the planar scanner [1]. The method is based on using a low-cost receiver to retrieve the amplitude and phase of the signal. This paper explores the limitations of the method for different geometries and implements a multiprobe electromagnetic compatibility measurement system. Once the amplitude and phase are recovered, diagnostic techniques can be applied and also near-field to near or far-field transformations to calculate the field at distances defined by standards. The results demonstrate the good accuracy of the method in comparison with traditional electromagnetic compatibility laboratories.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
