Abstract
Tungsten samples were exposed to combined steady state and edge localised mode transient replication experiments in a linear plasma device; either in combined hydrogen plasma and high powered laser exposures at Magnum-PSI or steady state hydrogen plasma and superimposed plasma pulses created using a capacitor bank in Pilot-PSI. With each transient the surface temperature of the sample was elevated above the melting point creating a shallow molten layer. An apparent heat transport reduction in the near surface layer increases as a function of pulse number. Scanning electron microscopy analysis of the samples shows large scale grain enlargement down to several hundred to thousand micrometers below the surface as well as melt layer motion due to evaporative recoil from the molten surface. In the ITER divertor this would lead to severe embrittlement and enhanced erosion of the tungsten surface leading to reduced lifetimes for the plasma facing material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
