Abstract
This paper presents the reformation and fabrication resolved on the wire clamp and top plate (WCTP) design to eliminate the presence of lead finger bouncing resulting to high rejection of non-stick on leads (NSOL). Problem experienced was that the hollow or half-etched portion of the leadframe at the top and bottom units caused its bouncing effect. With the aim to improve localized massive NSOL defect, WCTP has been modified to provide positive bias to support its hollow part or the half-etched part of the leadframe at the top and bottom of the units. The re-designed WCTP was fabricated, extending its clamping with enhanced vacuum on top and bottom rows. The implementation of the improved WCTP design reduced the defect with 88 % improvement with the defect reduction during the lot runs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
