Abstract
The micro-hole is a key structure in multilayer printed circuit board (PCB), as it enables the effective transmission of electrical signals. At present, the most common way to machine PCB micro-holes is mechanical drilling using micro-bit. However, in the mechanical drilling of micro-holes, these holes are prone to burring at the hole mouth due to the micro-bit failing to cleanly cut through the first layer of copper foil on the PCB. Hole mouth burr can seriously affect the performance of the PCB, resulting in potential short circuiting or even ruining the PCB. To solve the above problems, this paper proposed to machine the first layer of copper foil on the PCB via micro electro-discharge machining (micro-EDM) to eliminate hole mouth burr. Compared with the mechanical drilling, micro-EDM is a form of non-contact machining, and the high temperature generated from the electric spark discharge can erode the first layer of copper foil, thus fully eliminating hole mouth burr. This paper performed a detailed study of the influence of spindle speed, machining voltage, pulse width, and pulse interval on hole mouth quality. After that, the technological parameters for eliminating hole mouth burr were obtained. Finally, under the effects of 20,000 rpm spindle speed, 26 V machining voltage, 4 μs pulse width, and 8 μs pulse interval, a micro-bit with a diameter of 200 μm was used to perform micro-EDM of the first layer of copper foil. From the machining results, it can be known that the PCB micro-hole was possessed of overall good quality, with good hole wall surface quality and almost no visible hole mouth burr.
Highlights
Due to spatial restrictions in product design, multilayer printed circuit board (PCB)has been widely used in electronic products [1]
In multilayer PCB, micro-holes can be used to enable the transmission of electrical signals, so they are the important structure of multilayer PCB
Mechanical drilling based on the micro-bit is the most common technique mechanical drilling based on the micro-bit is the most common technique for At thepresent, machining of PCB micro-holes
Summary
Due to spatial restrictions in product design, multilayer printed circuit board (PCB)has been widely used in electronic products [1]. Due to spatial restrictions in product design, multilayer printed circuit board (PCB). The main way to machine PCB micro-holes is mechanical drilling by using micro-bits. During the mechanical drilling, PCB micro-holes are prone to burring around the edge of the hole due to the micro-bit failing to cleanly cut through the first layer of copper foil on the PCB [2]. The hole mouth burr can seriously affect PCB performance, potentially resulting in short circuiting or even ruining the PCB [3]. Researchers from all over the world have carried out extensive research on the mechanical drilling of PCB micro-holes from the perspectives of chip removal [4] and drill wear [5]
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
