Abstract
Cu−Ag−Zr alloy has an excellent combination of mechanical strength and electrical conductivity, and is a promising contact wire material for high-speed electrified railways. An investigation of the electritrobological behavior of Cu−Ag−Zr wire is presented here. Wear tests are conducted under laboratory conditions with a specified sliding wear tester that simulated train motion under an electrical current applied across the sliding interface. The Cu−Ag−Zr alloy wire is slid against a copper-based powder metallurgy strip used in railway systems under unlubricated conditions. Worn surfaces of the Cu−Ag−Zr alloy wire are analyzed by scanning electron microscopy (SEM) and energy dispersive X-ray spectrum (EDS). Within the studied range of electrical current, normal pressure, and sliding speed, the wear rate increases with increasing electrical current and sliding distance. Adhesive wear, abrasive wear, and electrical erosion are the dominant mechanisms during the electrical sliding processes. Compared with a Cu−Ag contact wire under the same test conditions, the Cu−Ag−Zr alloy wire has much better wear resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.