Electrothermal Performance of Heaters Based on Laser-Induced Graphene on Aramid Fabric.

Abstract

Nanostructured heaters based on laser-induced graphene (LIG) are promising for heat generation and temperature control in a variety of applications due to their high efficiency as well as a fast, facile, and highly scalable fabrication process. While recent studies have shown that LIG can be written on a wide range of precursors, the reports on LIG-based heaters are mainly limited to polyimide film substrates. Here, we develop and characterize nanostructured heaters by direct writing of laser-induced graphene on nonuniform and structurally porous aramid woven fabric. The synthesis and writing of graphene on aramid fabric is conducted using a 10.6 μm CO2 laser. The quality of laser-induced graphene and electrical properties of the heater fabric is tuned by controlling the lasing process parameters. Produced heaters exhibit good electrothermal efficiency with steady-state temperatures up to 170 °C when subjected to an input power density of 1.5 W cm–2. In addition, the permeable texture of LIG–aramid fabric heaters allows for easy impregnation with thermosetting resins. We demonstrate the encapsulation of fabric heaters with two different types of thermosetting resins to develop both flexible and stiff composites. A flexible heater is produced by the impregnation of LIG–aramid fabric by silicone rubber. While the flexible composite heater exhibits inferior electrothermal performance compared to neat LIG–aramid fabric, it shows consistent electrothermal performance under various electrical and mechanical loading conditions. A multifunctional fiber-reinforced composite panel with integrated de-icing functionality is also manufactured using one ply of LIG–aramid fabric heater as part of the composite layup. The results of de-icing experiments show excellent de-icing capability, where a 5 mm thick piece of ice is completely melted away within 2 min using an input power of 12.8 W.