Electrospun Cellulose-Acetate/Chitosan Fibers for Humic-Acid Removal: Improved Efficiency and Robustness with a Core-Sheath Design.

Abstract

Recycling biomass waste into functional materials has attracted much attention, and a rational structural design can make more effective use of each component. In our previous work, the fabrication of electrospun cellulose-acetate (CA)/chitosan (CS) adsorbents for humic-acid (HA) removal guided by the intermolecular interaction mechanism was demonstrated. Herein, a core-sheath structure was designed via one-step co-axial electrospinning, where a mixture of CS and CA was employed as the sheath layer to efficiently adsorb HA, and cellulose nanocrystals (CNCs) derived from waste cotton fabrics were incorporated into the CA core as load-bearing components. Compared to the non-layered electrospun CS/CA fibers, all the CS/CA–CNC fibers with a core-sheath structure exhibited smaller diameters, greater homogeneity, and significantly improved mechanical strength. Meanwhile, their maximum adsorption capacities towards HA had no significant differences. Even after the complete hydrolysis of CA into cellulose, the electrospun fibers maintained the fibrous structures and showed a higher tensile strength while exhibiting an acceptable adsorption capacity towards HA. Therefore, this work demonstrates the importance of rational design in the efficient preparation of functional materials and the feasibility of using electrospun core-sheath fibers derived from biomass wastes for the removal of water contaminants.